Competition Touring Car – ARC (Advanced RC Car) – A10-25

kr 7.499.00

1 på lager

Produktnummer: AC-R100038 Kategori:

Beskrivelse

May be an image of offroad vehicle and text that says 'ARRC Cor A10 -25 When the A10-23 was launched in 2023, detailed changes were made to boost its performance over the A10. Striving to further improve the A10 platform, ARC has been busy testing and developing new parts over the past 18 months to further increase performance We have incorporated all these learning to deliver the new A10-25.'

May be an image of offroad vehicle and text

May be a cartoon of skateboard, poster and text

May be an image of helicopter and text that says 'PERFORMANCE The A10-25's lower and motor bulkheads are designed with pins on the bottom locate these components precisely the chassis. Meanwhile the upper bulkheads also feature locating features fit the lower bulkheads. This ensures the A10-25 can be assembled with greater precision and allows the setup be precisely maintained. The new motor bulkhead comes with ball bearing below the 20T center pulley prevent belt flyover during hard acceleration and braking also helps to significantly extend the lifespan of the drive belts.'

May be an image of blueprint and text

May be an image of text that says 'NEW SUSPENSION For the A10-25, we have removed the traditional carbon shock towers with aluminum shock towers that connect directly to the chassis and sides the bulkhead. This allows the shock absorber geometry to be precisely fine-tuned in smaller increments. This design means the shock angle isno longer limited by the holes on the shock towers, with shock angle adjusted by adding or removing shims. 0 The new rear active shock mount allows suspension behavior to be further fine-tuned. For example, when traction too high and rear rotation is insufficient, engaging the active suspension can increase off-power steering.'

May be an image of text that says 'Lastly the A10-25 features a new 5.8mm titanium lower pivot ball design for use below the steering block. The specially designed pivot ball allows an M3x4 round head screw to be installed onto the bottom of the pivot ball. This design significantly reduces the likelihood of the ball pulling out of the arm socket during accidental impact. C'

Kan være et bilde av leke og tekst som sier 'DURABILITY The steering block of the A10-25 is now made from 7075- T6 Aluminum. The new steering block together with the zero-play design allows play to be removed between the steering, bearing and wheel hex adaptor. 3.0 The new steering block is completely different to the old plastic design. By redesigning the offset and putting the wheel axle in its optimal position, the A10-25 delivered maximum mechanical traction and cornering performance.'

Kan være et bilde av tekst som sier 'The shims below front steering arm is design to set the maxima steering angle by touch on the front lower arm, the default shims set the steering angle in 25 degree. The new front DJ CVD features a new big bore structure, with the internal drive shaft pin diameter increased from 1.5mm to 2mm. The new DJ CVD case made from lightweight, hard-anodized aluminum reduce rotating mass without sacrificing durability and performance.'

 

Omtaler

Det er ingen omtaler ennå.

Bli den første til å omtale “Competition Touring Car – ARC (Advanced RC Car) – A10-25”

Din e-postadresse vil ikke bli publisert. Obligatoriske felt er merket med *

Dette nettstedet bruker Akismet for å redusere spam. Lær om hvordan dine kommentar-data prosesseres.

Relaterte produkter