Princess Yacht – Hull w/HW – 960mm (With decals)

kr 4.399.00

Tomt på lager

E-post når lager er tilgjengelig

Produktnr: 1105FWHW Kategori:

Beskrivelse

 

Princess Yacht  – Fiberglass – 960mm (Hull with hardware)

Most of the general RC boats in this class are made from moulded plastic material. This boat is made by 4 layer ultra strength fiberglass material. Every part and the hull itself are finished by hand Made procedures, which gives it a awsom look and finish.

It's not only stronger than a normal boat, but it also reduces the friction against the water surface during accelerations.

The boat is 960cm long and can with the right setup reast 70km/h.

If you are looking for one of the best, if not the best quality on the market, this is it. 

Included:

  • 960mm 4 layer hull with decals
  • Hardware includedHarHNNeraWa

Spesifikasjoner:

  • 960mm 4 layer hull with decals
  • Propeller: 2 blade CNC alu propell 
  • Drive line included – Drive system 5.0 x 4.0mm collect, 4mm flex cable, 4mm drive shaft, 4mm drive dog
  • Rudder: Lenght =43mm, high=75mmRrrr

To make it compleet, you need:

  • Radio transmitter and receiver
  • Motor
  • ESC
  • Batteries
  • Servo
  • Charger
     

We will support you to select the products you need based on your request and ambitions.
 

Omtaler

Det er ingen omtaler ennå.

Bli den første til å omtale “Princess Yacht – Hull w/HW – 960mm (With decals)”

Din e-postadresse vil ikke bli publisert. Obligatoriske felt er merket med *

Dette nettstedet bruker Akismet for å redusere spam. Lær om hvordan dine kommentar-data prosesseres.