Klikk for større bilde
Princess Yacht - RTR - 960mmBESTILLINGSVARE - Leveringstid ca. 4 uker.
Princess Yacht - Fiberglass - 960mm (RTR)
Most of the general RC boats in this class are made from moulded plastic material. This boat is made by 4 layer ultra strength fiberglass material. Every part and the hull itself are finished by hand Made procedures, which gives it a awsom look and finish.
It's not only stronger than a normal boat, but it also reduces the friction against the water surface during accelerations.
The boat is 960cm long and can with the right setup reast 70km/h.
If you are looking for one of the best, if not the best quality on the market, this is it.
- 960mm 4 layer hull with decals
- Propeller: 2 blade CNC alu propell
- Drive line included - Drive system 5.0 x 4.0mm collect, 4mm flex cable, 4mm drive shaft, 4mm drive dog
- Rudder: Lenght =43mm, high=75mm
- Motor - New upgraded brushless 3660 motor - 1620KV (water cooled)
- ESC - 125A with BEC
- S3003 Steering Servo
- Instruction Manual
- Radio transmitter and receiverRrrrrrrrrfMMMMddHarHNNeraWa
- Length: 960mm
- Beam/Wide: 230mm
- Hight: 250mm
- Hull type: 4 layer Fiberglass (FRP)
To make it compleet, you need:
- Batteries (11.1V or 7.4V - not included)
- Balance Charger (not included)